Installing Coloured Steel Fencing

Installing Coloured Steel Fencing

Tools & Materials Required:

String line, Shovel, Spirit level, Tape measure, Tin Snips, Hacksaw, Drill, Hex head adapter, Wheelbarrow, Concrete, Tek Screws, Posts, Rails and Fence sheets.
Step 1:

Place a string line along your proposed fence site approximately 300mm above the ground. Make sure you know the difference between the posts(uprights) and rails(horizontals) as in Diagram A.

Diagram a

Step 2:

Dig holes at 2375mm centres along the length of the fence line. If longer or shorter panels are being used make the necessary adjustment. Bottom rails can be used to measure the distance between hole centers. Holes should be made to measure 250mm x 250mm x 600mm deep. In soft sand areas the holes will need to be larger. If the fence is to be erected with a lattice top refer to Diagram E before proceeding.

Step 3:

Concrete in the first post. Make sure that you have marked where the bottom rail will be screwed in usually 1805mm from the top of the post. Keep the bottom rail approximately 30mm above the ground so that it can drain water after the fence is erected. Ensure that the post is straight using a spirit level. Screw the remaining posts together back to back as in Diagram B and mark them where the bottom rail is to be fitted. Place posts in holes and screw top and bottom rails into place. At this stage the fence frame will be leaning to one side – away from the string line. Concrete the posts into place one by one. As each post is concreted in place it should be checked that when it touches the string line it is also straight with the spirit level. Concrete footings should be sloped away from the post as in Diagram D. Also concrete footings should not be any more than 50mm below the bottom rail as in Diagram D. Preferably footings should be 30mm below the bottom rail for maximum strength.

diagram bStep 4:

After all posts are concreted into place it is time to let the concrete dry. Quick setting concrete can be left for one hour but self mixed concrete will normally take 24 – 48 hours to set. Once set the sheets can be fitted into the frames. This is done by removing the screws in one corner of the top rail and hinging the rail on the other corner as in Diagram D. Three sheets are then placed between the top and bottom rails letting the top rail down as each rib is pushed into it. Make sure that the sheets are overlapped as in Diagram C and inserted in the order of Diagram D.

DIY Fencing Perth

Step 5:

Finish by screwing the remaining tek screws in place – one each side of the post where the rails are fitted. Use the coloured tek screws so that they blend in with the fence. Your fence is now complete.

 

We provide affordable DIY fencing to all of Western Australia including: Country WA and Perth including Osborne Park, Scarborough, Innaloo, Tuart Hill, Scarborough, City Beach, Stirling, Karrinyup, Balcatta, Duncraig, Greenwood, Kingsley, Woodvale, Edgewater, Joondalup, Cottesloe, Subiaco, Nedlands, Claremont, Armadale, Kelmscott, Gosnells, Shelley, Willetton, Bentley, Canning Vale, Thornlie, Maddington, Cannington, Manning, Belmont and Victoria Park.

Leave a Reply

Your email address will not be published. Required fields are marked *